I just purchased today a miller AEAD 200le welder. Serial # HE802574. The engine runs fine and the 120v plugs work but it won't hold an arc while welding. I don't know much about the internal workings of the machine so I tried to pull up the manual on here but it brings up a machine with a dial control for amperage and this is one of the old machines where you still have to switch around the cables. Anyone have any ideas what it might be or where to get the proper manual for my machine? Thanks
Results 1 to 2 of 2
Hybrid View
-
10-13-2012, 08:25 PM #1
Junior Member
- Join Date
- Oct 2012
- Posts
- 1
Troubleshooting a miller AEAD 200LE
-
10-13-2012, 10:14 PM #2
Senior Member
- Join Date
- Aug 2008
- Location
- Orange, TX
- Posts
- 1,058
You need to enter your SN whem looking up the manual otherwise you get the most current revision.
http://www.millerwelds.com/om/o411b_mil.pdfMM200 w/spot controller and Spoolmatic 1
Syncrowave 180 SD
Bobcat 225G Plus LPG/NG w/14-pin*
*Homemade Suitcase Wire Feeder
*HF-251D-1
*WC-1S & Spoolmatic 1
PakMaster 100XL
Marquette "Star Jet" 21-110
Reply With Quote
