Just picked up my new welder and was going to start the installation of my electric service for the unit. I thought I could use 8 AWG like most normal 220 circuits, but I'm concerned that it may not meet the needs.
I will be putting in a dedicated branch circuit and it will be about a 35 foot run. Does anyone have experience setting up service for this welder? Would the 8 AWG get the job done or should I look at 6 AWG or larger?
Thanks in advance,
Results 1 to 10 of 18
Thread: Service supply lines
10-12-2012, 10:53 AM #1Junior Member
- Join Date
- Oct 2012
Service supply lines
Last edited by MacDuff; 10-12-2012 at 11:10 AM.