Just wanted to virtually pat ya'll on the back - and say thanks. Nothing new being said here - but the answers I get and support from Miller (I receive an actual phone call instead of an email response to a question - which impressed me and reinforced my decision to buy blue) are top notch. People on this forum are willing and ready to help with sound advice that is given from real experience.
Finally ran my MM211 on 220V last night - flux core wire - and it ran just beautifully - thanks to your tips on tension adjustment and general setup - NO wire slippage - and it just COOKED that metal. Super happy.
Getting my bottle filled today - and have a knurled drive roll 'on order' from cyberweld along w/some anti-spatter spray - although I read on weldingtipsandtricks.com that he recommends using PAM cooking spray - anyone else here use that?
thx again all,
Results 1 to 3 of 3
11-29-2012, 07:09 AM #1Senior Member
- Join Date
- May 2012
Thanks guys & Miller Cust Service
11-29-2012, 09:04 AM #2Trailblazer® 302 Air Pak™
Miller Dynasty® 350
Millermatic 350P Aluminum
Lincoln LN-25 Pro
SuitCase® X-TREME™ 12VS
Millermatic® 211 Auto-Set™ w/MVP™ (Sold)
XR-Aluma Pro Gun
Spectrum® 625 X-TREME™
Thermal Dynamics® Cutmaster® 52
Victor Oxy/Acetylene Set
11-29-2012, 09:53 AM #3
Thanks guys &amp; Miller Cust Service
Yeah PAM works fine... And is good to keep spatter from sticking to threads and stuff...