Hi, I purchased a Hobart 235/160 AC/DC welder (made by Miller I believe). I have been doing some AC welding but want to try DC. Is the Amperage Range listed on the Electrode chart for AC and DC or just AC?
Using AC I'm currenlty using a 7014 3/32" rod at about 100 Amps and a 7014 1/8" rod at about 130 Amps. If you can provide some advice at what Amps I should be at using DC for these same rods I would appreciate it.
Any suggestions would be greatly appreciated.
Results 1 to 6 of 6
10-01-2012, 10:29 PM #1Junior Member
- Join Date
- Oct 2012
DC Arc Welding, where to start...