There are no commercially available Tig Tungsten Sharpeners in Australia that I have seen.
I ask my WS and tool shop guys all the time.
I have been using a small diamond wheel on an air die grinder for a few years now. Guessing the angle has been fine up till now.
I like different angles on my tungsten for different materials and also for weld type and available room in joint area.
I would like a trick looking sharpener that gives consistency without thinking about it too much.
This will be the easiest build I could think of.
I am sure others have even better ones that they have fabbed and I hope they will post images of theirs too.
The total cost of materials $3.00
Results 1 to 10 of 15
Thread: Tig Tungsten Sharpener
09-24-2012, 07:36 PM #1
Tig Tungsten SharpenerGrip it and Rip it