Trailblazer 325?????????????????

[weld007]

Finally Miller has caught up with the Lincoln. This 325 has the same basic theory as the Lincoln 305. Yes the 325 is vulnerable in a few areas. But after stripping one down. I actually like it, and its very suprising for me to like any engine drive of Millers.

Do you like the Pipepro 350 or the Pro 300 Cruizer??
But i did get a chance to weld a bit with a 305G i liked the arc better than my 302TB but don't get me wrong i have no problems with my TB302 i like it aside from the fact it wont run a soft start grinder unless it's on high idle.

[cruizer]

The new 325 fires a wave form quite simular to the 350, and equally simular to the Ranger and Vantage. These are using IGBT's as its control out to a set of Diodes kinda like how a XMT350 works plus a few more do dads

As for the Pro300, its using basic SCR rectifier. Not the best in final arc quallity, though still an adequate machine