Bored, need a problem I actually can't figure out

[Tool Maker]

I did that right off, added a 48 volt transformer and a drive from a satellite antenna. It works well but not the instant control you get from a foot pedal.. May be you could tell me if its possible to buy a full operating schematic for an old machine like this and where I could get one. Thank you very much for your time. Mac

[cruizer]

I have all that, but honestly its not going to do you any good with this particular machine.

[Tool Maker]

I guess I'll just limp along. Thanks anyway Mac

[Electric4Life]

If You were to purchase an engine driven set-up to primarily weld 1/4"-3/8" Aluminum (using GTAW) that could be safely transported in the bed of a 1/2 Ton p/u....what set-up would you choose??

[weld007]

Baldwin filter number for TB 302 with robin engine? Cruizer or anybody that knows thank you.

[cruizer]

I use Luberfiner, its number is PH2835.

[cruizer]

If You were to purchase an engine driven set-up to primarily weld 1/4"-3/8" Aluminum (using GTAW) that could be safely transported in the bed of a 1/2 Ton p/u....what set-up would you choose??

Lincoln GXT, or Miller TB 302 for AC tig

Pretty much everbody uses a Spoolgun with Aluminum on engine drives, So A Miller 325, or Lincoln 305G would be best.