Start out with some 3/4 round rod cut about 3' pieces, then make a template from plate thats at least as thick as the rod. Tack the plate to work table. Tack one end of the rod to the template as shown. Heat and bend. Leave enough gap or bevel for 100% penetration. Weld with 7018 or mig
Results 1 to 10 of 16
Thread: build heavy chain
09-11-2012, 10:37 PM #1
build heavy chain
Last edited by weldonwelding; 09-12-2012 at 07:12 PM.
09-12-2012, 07:30 AM #2
Why not make the link in one piece, then put the middle piece in.Nick
Miller 252 Mig
Miller Cricket XL
Millermatic 150 Mig
Miller Syncrowave 200 Tig
Jet Lathe and Mill
Jet 7x12 horz/vert band saw
DeWalt Multi Cutter metal saw
Century 50 Amp Plasma Cutter
20 ton electric/hydraulic vertical press
60" X 60" router/plasma table
Vist my site: www.nixstuff.com
and check out some of my ironwork and other stuff
09-12-2012, 09:00 AM #3
why not?Originally Posted by monte55:292962
09-12-2012, 10:36 AM #4Senior Member
- Join Date
- Apr 2011
I am not a chain expert but I think you are missing the point of the middle piece, and monte55 is correct but you need to figure out how. Your chain is NOT safe like that and by no means "HEAVY" duty.MillerMatic 211 Auto-set w/MVP
Just For Home Projects.
09-12-2012, 10:53 AM #5
No your right.... its just HEAVY! Im sure its not gona break jus hangin there. I tried a few different ways before i did it this way and found that this was the fastest and easiest. To make a whole link u gota leave one side open for the next link.. then it doesnt go back on the template so it doesnt stay uniformed.
09-12-2012, 07:01 PM #6Member
- Join Date
- Aug 2010
- Chesapeake, Va
What is the chain for?Miller pro 300 perkins diesel, 30 amp spool gun , Hobart 210 with spool gun, Thermal dynamic pak master 75 all mobile all ready to go.
09-12-2012, 07:11 PM #7
Its jus for decoration.
09-12-2012, 07:15 PM #8
pic of what chain is used for
I thought i added this photo in the beginning
09-12-2012, 07:20 PM #9
Thats cool. If you had a Hossfeld bender you wouldn't need the heat...BobBob Wright, Grandson of Tee Nee Boat Trailer Founder
Metal Master Fab Salem, Oh 44460
Birthplace of the Silver & Deming Drill
1999 MM185 w/185 Spoolgun,1986 Thunderbolt AC/DC
09-12-2012, 07:24 PM #10
Yes they are very handy. One day i will invest in one... soon as my wallet recovers from paying for the ironworker i just got.