I had a need to hold two cylinders and my new Miller 211 welder. I had a lot of fun building it and I think it turned out pretty cool.
The frame is made by 1.25" square tubing and reinforced in the center because the thickness was only .065. The sheet metal I used was also .065 thickness. The 4" sides were 1/8" because I didn't feel confident that the .065 would hold up with the weight and constant movement over time. Plus, I always like to overbuild a little because I would rather not have problems in the future.
I still have to make a handle for it, and a place to wrap the cords. I left the front of the bottom shelf open in case I decide later to put a pull-out drawer in it.
This will be painted Miller blue of course.
If you like what you see, find us on facebook and "like" my page or follow me on twitter.
thanks for your interest and any comments!
Results 1 to 10 of 14
08-08-2012, 11:05 PM #1
Welding Cart for Miller 211 with 2 cylinders
08-09-2012, 07:14 AM #2
cool ! I like the fenders.
08-13-2012, 01:07 AM #3
08-09-2012, 08:06 AM #4
Very cool, you thought it out well!
08-10-2012, 06:05 PM #5Senior Member
- Join Date
- Feb 2012
Very nice cart.
08-12-2012, 10:04 PM #6
Very clean. I like it! I also like the way you put the edge on the shelf.
08-13-2012, 01:11 AM #7
08-13-2012, 01:10 AM #8
08-13-2012, 01:09 AM #9
08-13-2012, 07:32 AM #10