7018 3/32 uphill

[Diddle]

this is my 7018 3/32 uphill...it still needs some work

[moltenmetal]

Pause more on each side at the toes to fill in the undercut. Looking pretty decent though.

[Cornerstone]

I agree. Had an instructor who told me to pause for the count of 1-2-3. It was weird cause it almost felt like dancing the foxtrot. :0

[Sberry]

Same old pic. This winter maybe I brush up and get some new ones. Dirty old plate, I think it had been thru a fire.

[beamwalker]

pause long enough til you see the flux run down towards center. for example if you are on right side of weld you will see the flux kind of roll down towards the left then move left until the flux moves towards the right. dont know how to explain it any better. if you are in east tn i can show you on tb302

[jazond82]

Watch The crater fill it will become brighter then move And you can see The flux moving toward The puddle And change sides when it gets about an 1/8 awau

[Diddle]

thanks for the help I like that 1-2-3- count I had some time today to try it out

[wayne50]

Wish I could do as well.

[walker]

Looks good to me. Instead of the foxtrot, you might try a 1, 2, cha cha cha, 3, 4, cha cha cha..,.,

[beamwalker]

looks pretty good