It looks good
I see a lot of people using that type of mount for winches
They have the rear one then install one on the front and another on there trailer also 3 mounts and only need one winch
And yes a lot of welders go to the other welding web site and quite a few belong to the different tractor forums
Results 11 to 16 of 16
06-21-2012, 01:38 PM #11Backed my CATMA over your CARMA
OOP"S clumsy me
What would SATAN do ??
Miller Digital Elite (new)
Jackson EQC master (old)
Miller Trail Blazer 302 Air Pak
Spectrum 625 Extreme
Evolution Rage 3 saw
Craftsmen Atlas 12X36 Lathe
Half a ton of tooling
Rusty old truck
06-21-2012, 05:41 PM #12Senior Member
- Join Date
- Oct 2007
- Cave Creek Az
Good design, welds need a bit more practice, see if you can find a local guy for a few lessons. Also, biggest problem with having multiple winch mounts and one winch, is that the winch is usually somewhere else when it is needed (usually 100 miles away, at home in the garage).
06-21-2012, 05:50 PM #13
Yes, i so wish I had a teacher...teaching myself is hard.
UTube is a lil help...
06-29-2012, 01:20 PM #14
06-29-2012, 10:22 PM #15Senior Member
- Join Date
- Dec 2009
- Williams Lake, British Columbia
Very nice, well made and looks good. Keep posting your project on here, it's always appreciated.
07-04-2012, 09:59 AM #16
What did you use to remove the paint on the receiver?
I had a hitch welding project for my tractor, and used the paint remover you can buy at the local auto parts store but it didn't do a very good job.