advise on miller passport

[Jobpump53]

Any owners of this machine, have any thoughts concerns or advice on it.

I have been using a mm130 as a portable flux machine. Im in need of a machine with more power and ability. Im looking at ordering a passport next week.

Wanna here the thoughts from some members before i pull the trigger

Thanks

[Country Metals]

I actually own 3 passport plus and I have a spool gun for one. I also have a millermatic 210 and invision 352 MPA plus. The passport does a real nice job up to 1/4" with steel and stainless, it is a little weird with aluminum. I have never used a 211, but I would actually go with the 211 unless versatility and portability is needed. I have never used the internal bottle either. I only use .035 wire and it seems to like it the best.

[Jobpump53]

1/4? Is that with the 110v or is that on 230v?

Yes the reason for the passport in my case is for portabilty as a mig or flux machine on the go.

I have a mm252 spool package. So i dont need this around the house.


Does anyone else have these same thoughts on this unit? Also is there a different mo ile unit to recommend. I was considering multi 200 but no reveiws its so new, and price is a bit higher than the passport.

[Broccoli1]

Passport plus hands down over the MM211
It just welds so much nicer and is way more portable

Quite amazing machine on 120v
1/8" aluminum no problem