I recently purchased a used xmt 304. Upon looking up the serial number it dates to 1996 as a production year. I am fairly use to the machines. I know its drawing around 40 amps when I am using it to stick weld. I have never had to service these machines what kind of maintenance can I expect?? Should I be watching out for anything to go wrong with this particular machine?? Also I will be running it single phase. Does it matter what breaker to use? (50amp 60amp etc). I am currently set up with a 60 amp breaker in the garage. Is there a certain male end i should be putting on my power cable? Thanks for any input. Mike
Results 1 to 3 of 3
Thread: XMT 304 cc/cv 220v
05-11-2012, 04:05 PM #1Junior Member
- Join Date
- May 2012
- Milwaukee, Wi
XMT 304 cc/cv 220v
05-11-2012, 06:15 PM #2
Open er up, on the right side sits the output board, make sure all the 5/16 head bolts are within torque spec.
the torque spec is writen on the board.
05-11-2012, 07:53 PM #3
I think 1996 was the first year for that model...BobBob Wright, Grandson of Tee Nee Boat Trailer Founder
Metal Master Fab Salem, Oh 44460
Birthplace of the Silver & Deming Drill
1999 MM185 w/185 Spoolgun,1986 Thunderbolt AC/DC
Spool Gun conversion. How To Do It. Below.