I have been using a 6" table grinder for my tungsten. Basically, this was how i learned to TIG weld. However, this week i have seen a major difference in my welds when I used a new wheel. So, I am wondering how much money I should invest into a better grinding system? I do not have a ton of money laying around to blow on this. Buy, if there is a HUGE quality improvement then I will need to weigh the pro's on cons.
I am mainly welding 7005 Aluminum Tubing with a Diversion 165. I do not weld a lot of hours in a month. Maybe 15 to 20 hours at best.
What is the best value for tungsten grinding?
Your advise is grearly appreciated
Results 1 to 10 of 18
Thread: TIG Tungsten Grinding
05-02-2012, 09:21 PM #1Member
- Join Date
- Aug 2010
TIG Tungsten Grinding