Looking good.
Results 21 to 24 of 24
Thread: Setting up my place
-
05-17-2012, 09:27 PM #21
Senior Member
- Join Date
- Feb 2012
- Location
- wisconsin
- Posts
- 113
-
05-18-2012, 11:14 AM #22
Senior Member
- Join Date
- Sep 2005
- Location
- northern NJ
- Posts
- 1,565
If you weld 1/4" x 4" flat bar under your table top it will warp. You can weld it to the legs & then just a couple small welds to the top to minmize warpage. SI would suggest using angle & only tacking it on with small welds.
MM250
Trailblazer 250g
22a feeder
Lincoln ac/dc 225
Victor O/A
MM200 black face
Whitney 30 ton hydraulic punch
Lown 1/8x 36" power roller
Arco roto-phase model M
Vectrax 7x12 band saw
Miller spectrum 875
30a spoolgun w/wc-24
Syncrowave 250
RCCS-14
-
05-28-2012, 01:18 PM #23
Junior Member
- Join Date
- Mar 2011
- Posts
- 19
Won't do that then, I'll leave it the way it is right now. Just finished the shelf.
Originally Posted by MMW
-
05-30-2012, 02:35 PM #24
Senior Member
- Join Date
- Feb 2012
- Location
- wisconsin
- Posts
- 113
Looks good.
Reply With Quote
