Maxstar 150 STL Maxstar 6 pin help

[jontheturboguy]

I crunched the plug on my RCCS-6 finger control today.

I bought the 217796 six pin replacement plug from Miller.

Since there isn't an old plug to copy from, I need some help.

According to the manual for the plug:

#1 = black #2 = white 3 brown 4 green 5 red 6 red

Three questions:

1. Only 5 wires. Out of the six pins which one is left out?
2. Is the above color code correct?
3. Is the plug receptacle diagram in the 150STL manual looking head on at the plug or from "inside" the machine?

[cruizer]

The 2 reds are jumpered, #6 is particularly nessessary, otherwise your wiring is correct.

[jontheturboguy]

The 2 reds are jumpered, #6 is particularly nessessary, otherwise your wiring is correct.

Thank you sir.

Is the pin location diagram looking at the receptacle on the machine or the plug on the cord?

[cruizer]

Cord end off the controller is what I'm looking at in the tech manuals

[jontheturboguy]

Looking at cord end:
Going clockwise....

1 is at 7 o clock.
2 is at 9 o clock
3 is at 12 o clock
4 is at 3 o clock
5 is at 5 o clock
6 is dead center

[cruizer]

Well if you look at the plug end realllly closely, you'll see the #'s

[snowbird]

" Well if you look at the plug end realllly closely, you'll see the #'s"

I don't know for him, but for me the closer i get these days...the less i see..

Join the club, time for cheater lenses ;o))