hi, could never decide on how I wanted to store the 3/4" pony pipe clamps. Used a recycled piece of 4" pipe with flange, weld plate to inside flange bottom, Dropped 3/4" threaded rod into flange holes and weld, cut 1/4"x2" flat stock 3/4" wide and welded to 1" pipe coupling and then weld to 4" pipe. With inside plate on bottom I store my bar clamps inside the 4" pipe.I should have done this years ago. Takes up very little space and you can spot the length of each clamp.
Results 1 to 9 of 9
Thread: Pony pipe clamp storage
-
02-04-2012, 11:42 AM #1
Senior Member
- Join Date
- Oct 2006
- Location
- Illinois
- Posts
- 460
Pony pipe clamp storage
Last edited by BD1; 02-04-2012 at 12:12 PM. Reason: remove pictures
-
02-04-2012, 03:14 PM #2
Senior Member
- Join Date
- Sep 2005
- Location
- Salem ,Ohio
- Posts
- 3,658
That looks like it will work good...Bob
Bob Wright, Grandson of Tee Nee Boat Trailer Founder
Metal Master Fab Salem, Oh 44460
Birthplace of the Silver & Deming Drill
1999 MM185 w/185 Spoolgun,1986 Thunderbolt AC/DC
-
02-04-2012, 10:46 PM #3
Senior Member
- Join Date
- Nov 2008
- Posts
- 164
Cool idea. Keeps them handy but not in the way. Nice.
Professional firefighter (retired). Amateur everything else I try to do...
Oh yeah: GO BIG RED!
-
08-05-2012, 01:17 PM #4
Junior Member
- Join Date
- May 2011
- Location
- Oregon
- Posts
- 6
Very nice idea and sure beats leaning the clamps against a wall.
Terry
Portland, OR
-
08-07-2012, 06:52 AM #5
Senior Member
- Join Date
- Oct 2006
- Location
- Illinois
- Posts
- 460
Thanks, you can use the same idea use for storing shovels,rakes,brooms, anything with handle and it fits in corner of garage or shed.
-
08-07-2012, 11:02 AM #6
Senior Member
- Join Date
- Feb 2012
- Location
- wisconsin
- Posts
- 113
Great idea,looks good.
-
08-14-2012, 10:02 AM #7
Junior Member
- Join Date
- Feb 2011
- Location
- Far West Texas
- Posts
- 13
Nice pipe clamp stand, I think I might have to pull a copy cat and build one like it, lol.
Lone MIG Slinger!
-
08-18-2012, 08:47 AM #8
Member
- Join Date
- Aug 2009
- Location
- Ocala Fl.
- Posts
- 32
Nice job, great idea!!!
-
08-18-2012, 09:34 AM #9
Senior Member
- Join Date
- Oct 2006
- Location
- Illinois
- Posts
- 460
Thanks. I got quite a few scraps of 4'' with flanges. I made up a spool piece about 36'' face to face on flanges. Then had a 20'' square piece of plate that I
welded some 5/8'' studs to so they match the flange bolt pattern on center. Now I have a roll about flange to flange table top. Just remove when storing.
Reply With Quote
