Does any one have plans for a nice welding/fabricating table
Results 1 to 2 of 2
Thread: table
-
01-22-2012, 07:56 PM #1
Junior Member
- Join Date
- Jan 2012
- Posts
- 5
table
-
01-22-2012, 08:55 PM #2
Senior Member
- Join Date
- Sep 2005
- Location
- WY...armpit of U.S.A.
- Posts
- 636
If you care to use the 'search' feature here, you'll undoubtedly end up with more ideas than you can incorporate into ten welding/fab. tables. Also, try checking out the 'Go to Welding Projects' section on the right of the screen for short write-ups and pictures of similar projects. As far as specific plans with measurements and such included, you may have a bit more difficult time of it. Still, reference a photo with some other features or tooling on it that can be scaled to approximate the table dimensions and you should have a near match...or just go with your own set of dimensions mandated by your height or other physical or job specific needs.
Miller 251...sold the spoolgun to DiverBill.
Miller DialArc 250
Lincoln PrecisionTig 275
Hypertherm 900 plasma cutter
Bridgeport "J" head mill...tooled up
Jet 14 X 40 lathe...ditto
South Bend 9" lathe...yeah, got the change gears too
Logan 7" shaper
Ellis 3000 band saw
Hossfeld bender w/shopbuilt hyd.
Victor Journeyman torch and gauges
3 Gerstner boxes of mostly Starrett tools
Lots of dust bunnies
Too small of a shop at 40 X 59.
Reply With Quote
