Hi everyone,

I finally got round to getting my TIG setup running, and after a while of tinkering and getting used to tigging again, I made my first piece with it this week. it's a smaller version of the last outdoor table I made, to be used as a drinks table or a bench for sitting on.

i got a little bit impatient in the finishing and dressing stage unfortunately, and the areas where the legs join the frame could be a bit tidier (there's some undercut and gouging in the blended areas that i'd have preferred to avoid) but all in all it came out much better than the first table in terms of squareness and dimensional accuracy.


some pics: