I would like to make something like this, doesn't have to be as extensive. I need it to mount to the ceiling above a car and be able to swing 2 lcd panels around either side of a car on a dyno. Anyone have a clue where I can get or make some swivel pieces similar to these? Thank you for your time,Dk
Results 1 to 3 of 3
08-21-2011, 05:12 AM #1Junior Member
- Join Date
- Apr 2011
- Frankfort KY
Chassis dyno articulating arm lcd panel(s) mounthttp://www.dkGoodrich.com
EFI Tuning Solutions
106lb/min 11k RPM 1.8l
08-21-2011, 08:14 AM #2
Do not know how much you intend to spend... those things are expensive new... if you are not in a hurry, I would check local hospital and university surplus... they are always upgrading monitoring electronics...
You might take some time to get to know someone in maintenance or facilities management... you may uncover a goodmine..
Similar arms have been in use for CNC equip for many years... so industrial surplus.... or your locall scrap yard could be a good bet...
08-21-2011, 01:03 PM #3Senior Member
- Join Date
- Dec 2009
- Williams Lake, British Columbia
Get a machinist to make you to sleeves for a good size bolt that you can insert a UHMW washer in between, long enough that you'll be able to tig them on a some 1 X 2 X .100 rectangular tubing to each sleeve, then you can tig your wall mount at one end of tubing and your monitor mount at the other end.