Hi Guys,
Havent been on here for a while so i'll post the pics of my latest project. A 140cc shifter kart. I started with 1 1/4" Steel Tubing with .120 wall thickness and bent it up using a cheap Princess Auto bender (actually designed for pipe) but i used a grinder on the die and it worked allright after filling the tubing with sand.
After bending the main rails, i filled in, using rough measurements off a professional frame but most of it is my own design including the whole front end. its basically finished now except for a few finishing touches yet to do such as to mount the plastic sides properly and hook up the brakes.
Just a few pics to show it... i have more which i might post later if you are interested.
Results 1 to 5 of 5
Thread: Shifter Kart
-
07-09-2011, 03:50 PM #1
Senior Member
- Join Date
- Jan 2010
- Location
- Calgary, Alberta
- Posts
- 197
Shifter Kart
-
07-09-2011, 06:38 PM #2
Senior Member
- Join Date
- Sep 2005
- Location
- northern NJ
- Posts
- 1,569
Cool looking kart. More pics are always good.
MM250
Trailblazer 250g
22a feeder
Lincoln ac/dc 225
Victor O/A
MM200 black face
Whitney 30 ton hydraulic punch
Lown 1/8x 36" power roller
Arco roto-phase model M
Vectrax 7x12 band saw
Miller spectrum 875
30a spoolgun w/wc-24
Syncrowave 250
RCCS-14
-
07-10-2011, 12:08 AM #3
Senior Member
- Join Date
- Jan 2010
- Location
- Calgary, Alberta
- Posts
- 197
Thanks MMW!! I'll post some more pics of it tomorrow sometime.
-
09-19-2011, 06:42 AM #4
Junior Member
- Join Date
- Sep 2011
- Posts
- 4
Shifter kart
cool kart...
-
10-28-2011, 05:56 AM #5
Member
- Join Date
- Oct 2011
- Location
- Illinois
- Posts
- 58
I dig it. Simple, but pretty sweet lookin.
Any speed checks on it yet?Miller Mig 140 Autoset (2010)
Miller Syncrowave 250 (1996)
I have a lot to learn.
-Joe
Reply With Quote
