Electric Catamaran conversion

[Alumitech]

Check out this site for some ideas:

http://www.riversombrero.com/collections/all-products

Yea .. now thats what im talking about .. searched cobellas and mini paddle boats

there was one for a pelican paddle boat for $115.00 I was lookking at but no width dim's

has to be attacked to the rear deck tubes as i dont want to drill holes in the Pontoons .. another option was a reverse wale boatd tube fram with a visor .. or something like a t-top for center consel boats .

thanks for all the good comments .. Iplan on building a few of these To sell to folks on privat lakes that dont allow gas motors .
thanks Don

[Pass-N-Gas]

Attach the pivot points to your rear AL deck. The front and rear tie downs are in place.

This is my river shade and bed too:



Load tested to 1 fat welder, 3 fine ladies and one beer drinking lizard:




Your T-top has merit.. that would be a good spot to mount the solar panels..

[Alumitech]

Ok i think im done working on this time sucking money pit for a bit .. time to get out in the sun and buzz around a bit .
i think the paddle boat top will work for width .