I'm looking to improve the lines for my dry sump in my racer. I presently run almost 8' of -10 and -12 armored flexlines to the tank. I think this could be improved immensely with a nice hard line setup but as of yet haven't found the right tubing. I'll entertain both aluminum and steel if bends can be dealt with.
Many hours on Google doesn't find much mention of this minor fabrication challenge. Anybody know?
Results 1 to 10 of 11
Thread: Hard lines for a dry sump
05-08-2011, 03:44 PM #1
Hard lines for a dry sumpMiller Diversion 165
1966 Bridgeport Mill
Leblond 15x 35 Regal Servoshift lathe
Solberga SE 1425 Drill Press
small surface grinder
Tons of grinders and hand tools
Knife edge Balancing rollers
Heat and AC in the garage
Jags and racing Triumphs