what size nickel rod do I use to weld 1/8 " cast iron
Results 1 to 3 of 3
Thread: question about cast iron
-
01-21-2008, 08:50 AM #1farriel Guest
question about cast iron
-
01-21-2008, 05:52 PM #2
Senior Member
- Join Date
- Jan 2007
- Location
- Rosetown, SK.
- Posts
- 514
Seen your question earlier but our internet has been acting up so couldn't reply. I would use a 1/8 rod & start at about 60 amps. & do short welds. Peen with chipping hammer while waiting to run next section. Hope this helps.
-
01-21-2008, 06:18 PM #3
Member
- Join Date
- Feb 2007
- Location
- Blissfield, MI
- Posts
- 78
don't forget to pre and post heat! Very important!!
Modern Metalworking L.L.C
Blissfiled, MI
517-605-9481
Miller Dynasty 350 Tig runner
Hobart 3-phase mig
Hypertherm 1000 plasma
Mill
Lathe
Box break
Shear
Reply With Quote
