Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums
Miller Welding Discussion Forums - Powered by vBulletin

Page 2 of 2 FirstFirst 12
Results 11 to 13 of 13
  1. #11
    Join Date
    Oct 2013


    I got a 225G yesterday with same problem. Wont go to high speed under load when on turtle. Runs fine if left on rabbit.
    Duane, I did all these checks and everything checks good except on the ICM, pins G-E measured 2.5mvAC no load. I know you say 0 vac so does 2.5mv mean its bad?
    Also where to buy the icm if it is bad. M4less wants $236. Seems a little high to me?
    Thanks to all for giving this info

  2. #12
    Join Date
    Oct 2013


    Btw, pin D on my ICM does not have anything on it. Is that normal?

  3. #13
    Join Date
    Aug 2008
    Orange, TX


    Yes, normal. Terminal D isn't used on the Bobcat.
    MM200 w/spot controller and Spoolmatic 1
    Syncrowave 180 SD
    Bobcat 225G Plus LPG/NG w/14-pin*
    *Homemade Suitcase Wire Feeder
    *WC-1S & Spoolmatic 1
    PakMaster 100XL
    Marquette "Star Jet" 21-110

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Warning: Function split() is deprecated in /mnt/stor3-wc1-dfw1/357822/357839/ on line 79

Welding Projects

Special Offers: See the latest Miller deals and promotions.