Stainless security gate

[reggie]

I do have a question regarding the left hand side of the gate. I assume this is where it swings wide and customers can walk through. Maybe the picture angle or maybe something else: It looks out of square. Spacing between the gate and the frame seems narrower at the top and bottom than at the mid section. I am not criticizing your work. I am only wondering if this is the camera angle or what.

It's because of the amount of welds in the middle causing the distortion.

[HAWK]

Reggie,

Ya man. I know. It could have been accounted for in the welding procedure, but as Donald mentioned someone else (the owner) welded some on the project. Therefore, Donald had neither complete control nor responsibility for the final product.

It is a beautiful gate and most folks will neither notice nor think "it's not square" unless they're in the fabrication or related business.

Regardless it is nice functional work!