I just got my new chopsaw today and i want to make a stand for it. I seen on here a realy nice stand that had suports that slide in the sides, i used the search but had no luck... any help or ideas would be great thank you.
Results 1 to 10 of 38
Thread: Chop saw stand?
09-01-2007, 06:38 PM #1
Chop saw stand?
09-01-2007, 06:48 PM #2
A piece of plate to hold your saw and 4 legs from angle or small pipe cut to suit height. Cut about a 10* angle on the top and bottom of the legs so they go outward a little at the bottom...BobBob Wright, Grandson of Tee Nee Boat Trailer Founder
Metal Master Fab Salem, Oh 44460
Birthplace of the Silver & Deming Drill
1999 MM185 w/185 Spoolgun,1986 Thunderbolt AC/DC
Spool Gun conversion. How To Do It. Below.
09-01-2007, 07:18 PM #3
Here's one I made for my Porter Cable Dry Cut Saw. It is fully functional, yet compacts into a total space of 2' X 3'. I have to post another reply to get in all the photos.......Denny
09-01-2007, 07:20 PM #4
Hope this helps you a bit....Denny
09-01-2007, 08:15 PM #5
yorkiepap, Thank you very much...thats the one i was looking for all day.
09-01-2007, 09:02 PM #6
You saw it on Penton's Welding site on the Projects topic board......Denny
09-02-2007, 12:57 AM #7
A question for YorkiePap
Hi ya D,
Can you tell me the no load RPM's for your dry cut saw?.
Thats a sweet little rig. I like the wheels and cord winder additions.
09-02-2007, 04:50 AM #8
yorkiepap, wow thats a great looking stand. i would add a few bolts with wuing nuts to lock the extention in place ( or am i missing some thig ?) but other than that its freaking perfect. well thought out and looks verry helpfull.
just what i needd another project for my to do list.
hope i helped
feel free to shoot me an e-mail direct i have time to chat. firstname.lastname@example.org
summer is here, plant a tree. if you don't have space or time to plant one sponsor some one else to plant one for you. a tree is an investment in our planet, help it out.
09-03-2007, 04:29 PM #9
may have to build 1 like that for when I buy my chop-saw in Oct . with my b-day money( also getting a Hobart ac stickmate 235 amp)
09-03-2007, 06:07 PM #10
Roller Ext. & Table locking sys.
I have attached photos of how to set up your locking system for the extension & table. The entire sys. is made of 1 1/2" & 1 1/4" sq. tube for telescoping the attachments. I drilled 1/2" holes about 2" from the ends, welded 5/16 X18 nuts over the 1/2" holes. Then used 1"L 5/16" bolts with a 2" piece of 3/8" rod welded to the head of the bolt for tightening leverage. Quite simple & effective.
To SineWave: The Porter Cable Dry Cut Saw is rated at 1300rpm and the Freud Diablo 14" carbide blades I use are rated at 1800rpm. Thanks for the compliments.......