I need to install a outlet for my new welder, What would be the best amp breaker I should use? Could I get by using a 40amp Breaker?
Results 1 to 3 of 3
Thread: New Syncrowave 200
05-10-2006, 06:19 PM #1Tungsten Guest
New Syncrowave 200
05-11-2006, 01:39 PM #2
You might get by with a 40 amp breaker if you don't push the machine, I would recommend to get a 60 as asked for since you are going to need to wire anyway.Regards, George
Hobart Handler 210 w/DP3035 - Great 240V small Mig
Hobart Handler 140 - Great 120V Mig
Hobart Handler EZ125 - IMO the best 120V Flux Core only machine
Miller Dynasty 200DX with cooler of my design, works for me
Miller Spectrum 375 - Nice Cutter
05-15-2006, 08:33 AM #3Junior Member
- Join Date
- May 2006
I would sy be sure your lines can hold a 60 amp... to many times i hve seen people overloading there lines tthat come in to the breaker box. turn everything on in your shop and get a amp probe and be sure you have room for another 60 amps..