Hello,

I bought a used plasma cutter. It seems it has two capacitors that are blown. They are the size of a "D" battery and say Phillips 1000uf and UR=300V. I am guessing this is all the information that I need to buy two replacements and solder them to the main board. I have them off of the board.

The capacitors also say 157 93075, M HP 9820:, and 25/085/56.

I was also wondering if anyone here had a schematic to tell me which terminal went to the outside of the board (the top) so I could solder the proper ones back in correctly.

Thanks for any help here.