Got an older Syncrowave 300....built in 1985, Single Phase...and want to hook it up 230 Volts.
The manual shows hook up is 2 hots.....My supply is 2 hots, a neutral and ground.
I can figure out the ground...but what should I do with the Neutral wire?
Anyone out there familiar with this older machine?
Thanks
Results 1 to 2 of 2
Hybrid View
-
01-08-2008, 06:53 PM #1
Junior Member
- Join Date
- Jan 2008
- Posts
- 1
Little help regards Syncrowave 300
-
01-08-2008, 09:29 PM #2
Member
- Join Date
- Nov 2007
- Location
- Ontario, Canada
- Posts
- 72
The neutral is not used in your application. The grounded conductor is attached to the frame of the machine. There should be a lug for this purpose close to where the two hot wires connect.
XMT-300 with S-64 wire feeder.
Lincoln HI-FREQ modified to run XMT.
Esab PCM-875 plasma cutter.
Miller Spoolmatic-1
Miller PC-300 pulser
Miller Optima pulser
Reply With Quote
