I've got a place on my Jeep that I'm working on and the sheet metal is stretched enough to create an oil can on the panel. I need to shrink it and have looked at a few posts on youtube to learn more about the process. So a few questions:
1. Rather than an oxy/fuel torch can I use my TIG torch to heat the area?
2. Would the application of dry ice improve the shrinking over a wet rag?
3. Hammer and dolly or not? Some say it's absoolutely necessary, buy most seem not to do it.
Thank in advance!
Results 1 to 3 of 3
01-14-2011, 07:27 PM #1
Metal Bumping? Shrinking an "oil can"
Last edited by nocheepgas; 01-14-2011 at 07:36 PM.Miller Syncrowave 200
Homemade Water Cooler
60 year old Logan Lathe
Select Machine and Tool Mill
More stuff than I can keep track of..