Welder insulated Covers

[engnerdan]

Do you sell to the US? If so what is the shipping? I just tore my Blue miller cover because it frooze to the welder, what a POS I thought it was suppose to be water proof. I guess not water went right through.

-Dan

[cruizer]

Do you sell to the US? If so what is the shipping? I just tore my Blue miller cover because it frooze to the welder, what a POS I thought it was suppose to be water proof. I guess not water went right through.

-Dan

Yep, send all over the cold climates in the world. I'd guess that shipping to you would be around the $40 mark

[c wagner]

That's a slick setup for you welder, I like it.

The company I work for builds the aluminum skid and boxes, the steel roll out is made in Edmonton by these guys: www.cargobed.com

[c wagner]

Again I have to thank you Clay , when you get yours , I'd like to see the cover on the miller units if you don't mind taking a couple more pictures.

I just picked it up from the bus and it looks good.
My wife is jealous... I told here it was a Christmas present for my welder since it has been good too me this year.
Her comment to me was "You probably won't spend that much on me!!!" ... gotta hate it when she's right.

I'll try and get it installed tomorrow and get some pictures before the sun goes down. I should have pics in this thread by Sunday if not before, I guess I have to go visit some in-laws on the weekend.

[blackbeard's welding]

is it safe to run the welder when it is fully buttoned up?

[cruizer]

is it safe to run the welder when it is fully buttoned up?

I custom vented so that they are always open, the only thing that zips up is the control panel so yes.

[cruizer]

Also have em for the classic 3D (Kubota or Perkins) Have to move the exhaust stack hole on the continental versions. Zippered both sides and closeable rad door $200

And Vantage 300/400 (flapped on the side vents and rad) full zippered on one side, closeable rad doors and zippered control panel $200

[c wagner]

Well I managed to make some time today and put it on.
I even managed to get some pictures during the day out in the sun.

1. 3/4 view of the front
2. Rear showing the two cutouts at the vents
3. Front flap zipped down, vent hole at bottom, cables come out the bottom of the zippered front
4. Zipped up, rolled up and snapped up
6. Top view shot from the engine side toward the operator end, velcro flap for top service door, exhaust cut out, hook opening, fuel cap opening

[c wagner]

Last picture.
8. Velcro flap and top service door open.

All in all it looks pretty well designed and built, I look forward to testing it out.

[sturugged]

Those are some very good shots of the unit in service . Thank you Clay, I see now why Jeff has sold so many of these covers, the fit is first rate and they really look top notch!