Generally I fabricate complete swingarms for clients out of 4130 chromoly in either round or aerostrut tubing, however, a friend of mine needed his stock swingarm lengthened and didn't have the money for a complete new swingarm so I just lengthened his stock one. Here are few before and after pics. I don't have any of the swingarm on the quad as of yet. I just finished painting the swingarm this morning and will install it tomorrow. Thanks for looking, Mike.
This the the swingarm prior to cutting.
Here is the swingarm cut and with the extension pieces mocked into place
Results 1 to 10 of 10
Thread: Banshee Swingarm extenstion
09-26-2010, 02:50 PM #1
Banshee Swingarm extenstion
09-26-2010, 02:51 PM #2
Here are a few pictures of my welds.
This is the sub-structure fabricated and ready to weld between the two halves.
Last edited by zmotorsports; 09-26-2010 at 02:55 PM.
09-26-2010, 02:52 PM #3
These next two pictures of are some small gussets that I welded in place.
This last picture is of the complete swingarm ready for paint and installation.
09-27-2010, 12:21 PM #4
I use to have a Banshee and the problem I see is that your weld will not match up to the factories, they are too pretty.
Here is mine, at 50, I run mine real fast, "for a short distance", as the younger one chase me, then shut it down and say, hey, already won, why go further.
09-27-2010, 02:42 PM #5
09-27-2010, 08:22 PM #6Member
- Join Date
- Apr 2010
I am jealous