a tobbogan

[Mikka]

This is my first real welding project. A couple years back I purchased a MIG with the intention to take an evening course on welding. Never did take the course and taught myself. Please do not critic the welding

I hunt from September until December in a very swampy area and end the season in snow where a trailer does not cut it behind the 4wheeler. I had and old heating oil tank and with some square and round tubing and some thinking this is what it came out like!

I cut the tank in an "L"shape welded it together to form the basic form. I caped the front and back with a steel skirt I took from an old hot water tank the square tubing was used to make the side more rigid while providing height for furure load. I built the pull bar from round tubing. Inside the bar I included a spring system to take away the jerking when riding, the ball coupler also turns 360 degrees to avoid tork when the tobogan is not on the same plane as the 4wheeler.

[jontheturboguy]

Its not structural so I wont say anything about the welds...haha. But your creativity and hard work have paid off. Great project! Wonderful job!

[ohsobad_chevy]

LMAO!!! What does that beast weight?

[wroughtnharv]

I love the thinking behind this. I think it's great.

Keep in mind that anyone can learn to weld, thinking, that's another thing all together.

[flathead4]

Yes, that L-shape cut is ingeneous. I can't quite tell; do you have runners on the bottom? You'd hate for that to get sideways on a slope and pull you into the swamp.

[ohsobad_chevy]

I love the thinking behind this. I think it's great.

Keep in mind that anyone can learn to weld, thinking, that's another thing all together.

Very true.

[welder_one]

you might wanna make those runners outta some hard plate..... something tells me with weight and all involved, it wont take it long to wear a hole right through that dilly..... other than that, nice job thinking (wont critique welds)