i have an old dialarc hf and although i see lots of sparks jumping between the electrodes on the front of the unit i'm wondering if everything is happy. the manual says not to dress the electrodes but to replace them...when do i know when they are shot? and where is a good place to buy replacements?
Results 1 to 2 of 2
Thread: inspecting hf electrodes
12-26-2007, 12:29 PM #1Junior Member
- Join Date
- Dec 2007
inspecting hf electrodes
12-26-2007, 01:09 PM #2
Lots of sparks is normal. I've never seen them wear out.XMT-300 with S-64 wire feeder.
Lincoln HI-FREQ modified to run XMT.
Esab PCM-875 plasma cutter.
Miller PC-300 pulser
Miller Optima pulser