Well, I'm happy to report that the bucket tipper served it's purpose. It was actually a bigger convenience than I expected. I did not use much of the paint out of that 5 gallon bucket but thanks to the tipper (and a screw on pouring spout) I did not loose a drop due to spillage. I could have poured with it sitting on the living room carpet.....
The mixer stand worked as well. But, as could only be expected there is a good bit of dripping from the "beater" once you raise it up out of the paint. I just put a bucket of water under it, lowered it back down and ran the mixer for a minute which cleaned the mixer like new.
I am not a painter, and do very little painting other than with a rattle can so when I get that mixer stand back home I plan to make adapters to use it for other purposes. It needs a heavier base and since the upright is simply 2" tubing and the drill holder is bolted to a short bit of receiver tube which will slide on the upright post, it would not be hard to adapt the stand to just about any use that I can imagine. The bucket tipper will probably end up being the permanent storage location for a 5 gallon can of kerosene or diesel for the salamander when it gets home.
Results 11 to 13 of 13
Thread: "Bucket Tipper"
09-17-2010, 06:36 AM #11Larry
"I feel for the man who can only spell a word one way"......Mark Twain
Lincoln AC225-S (OLD/Copper Wound)
Lincoln Weldpac 100
Miller Matic 180 (auto set)
Miller Spool gun 100
Miller Spectrum 375 Extreme
Victor Super Range II
09-21-2010, 10:59 PM #12Junior Member
- Join Date
- Aug 2010
09-23-2010, 06:59 AM #13Junior Member
- Join Date
- Jan 2008
- east central il