Hey guys, i have a backup welder apart from my 210. Its for when i just wanna flux weld something and dont wanna set up the bigger one.
My question is that the wire is always hot. I heard from some people that this is normal on this model of welder. When i push the trigger, the wire comes out perfectly. Its kinda a pain in the ***, cause i am so used to the wire only being hot when the trigger is pushed.
If anyone else can enlighten me thanks, as i don't wanna fix something that isn't broken.
Results 1 to 2 of 2
Thread: Lincoln Handymig 100 question?
12-20-2007, 08:50 PM #1Junior Member
- Join Date
- May 2007
Lincoln Handymig 100 question?
12-20-2007, 09:03 PM #2Senior Member
- Join Date
- Oct 2007
I had from, a deal, a little 90amp century. The wire was always hot. I did not like it. The welder was to small anyway so I sold it. I got 100 bucks for it, way more then it was worth. I think the always hot wire is normal for the lower amp (cheap) machines.Tim Beeker,
(my side bussiness)
Miller Synchrowave 350LX with tigrunner
Esab 450i with wire feeder
Thermal Dynamics cutmaster 51 plasma cutter
Miller aircrafter 330 - sold
Marathon 315mm coldsaw
vertical and horizontal band saws
Dewalt cut off saw
Sand blast cabinet
lots of hand grinders