This is how I made a holder, it is not the only way and it is most likely not the best way. I started this thread to help or motivate others.
If you are an expert you will find this stuff very boring.
Today I was sick of taking so much time to safely place my TIG torch onto the bench I decided to make a torch holder.
I used some 6mm or 1/4" mild steel round bar and a 75mm or 3" G clamp.
I started out by bending the bar into shape and cutting to a rough length.
Results 1 to 10 of 38
Thread: TIG Torch Holder
07-18-2010, 05:05 AM #1
TIG Torch HolderGrip it and Rip it