If you are going to weld two pieces of metal together, one is 1/16'' thick and the other is 1/8'' thick. What does the manual say, do they give you an approximate setting for the two. Or is it only for one size only.
Rob
Thanks Rob
http://www.1969supersport.com
Results 1 to 3 of 3
Thread: miller 140 auto ser
-
12-10-2007, 11:41 PM #1
Junior Member
- Join Date
- Dec 2007
- Location
- two rivers wi.
- Posts
- 23
miller 140 auto ser
Last edited by rubadub; 12-11-2007 at 12:17 AM.
-
12-11-2007, 12:51 AM #2
Member
- Join Date
- Jun 2007
- Location
- Scotts VAlley, CA.
- Posts
- 39
Rob,
I was taught that you set up for the thicker piece, and dwell less on the thinner metal as you do your pass. Best thing to do is take a couple of test coupons, and just run a few beads to see what setting and speed works for your skill level.
HankMiller Dynasty 200DX
Miller Spectrum 375 extreme
Miller Millermatic Passport
Meco, Victor, O/A
-
12-11-2007, 12:54 AM #3
Junior Member
- Join Date
- Dec 2007
- Location
- two rivers wi.
- Posts
- 23
Sounds good, thanks Hank
Rob
http://www.1969supersport.com/
Reply With Quote
