I am hobby welder. This is first attempt at building a smoker. I am using 12" or 14" steel pipe i think. Its wall thickness is 3/8. It is very heavy. I am stick and tig practicing. I didn't know steel was so hard to tig. I can make aluminum look much better than my steel welds. I will post more pics later, I have little time off. I am welcoming suggestions. I have never cooked on a smoker before. Just a grill man.(nat or propane,charcoal) I just been lurking here and there trying to see other designs. I have learned that heat control is key to smoking/barbequein' foods. I hope that this heavy pipe will hold heat and my design controls draft!!
Results 1 to 10 of 24
06-01-2010, 07:59 PM #1Junior Member
- Join Date
- Jul 2009