Airco MIG

[millrat]

Hi group,

Is it OK to post a Craigslist link if you aren't the seller?

millrat

[FusionKing]

Sure, do it now!!....esp if it's a good deal

[millrat]

Well, I think its a good deal. It depends on your perspective I suppose.

http://minneapolis.craigslist.org/da...702066978.html

The equipment was Miller.

I have one of these units that I restored - less decals. Blast and paint. Took every component apart and cleaned and lubbed as necessary. Replaced zero components, although it could use a new voltage label on the drum.

I wouldn't trade/sell for love nor money and it's a 1962.

This guy even has an extra gun/cable-hose assy. The one in the picture appears to be an MHE-20G spool gun. The gun alone is worth what he's asking. I like it because I can put the cable/hose assy. on my shoulder and move it around all day with about 40' of latitude and I don't have the weight hanging below my wrist. All this also puts less stress on the cable/hose assy..

Oh yea, running gear that acommodates two gas cylinders.

He may not have the other contact tips, but I know the gun will accomodate .030, .035, and .045 wire without changing rollers!

Check out Pro-Fax or ESAB for the replacement gun prices!

I haven't run alu. on mine, but i've run MS and SS.

Selenium might be "old tec" but they are smooth.

I also have some documents (Miller) that came with mine. Similar enough models to diagnose/repair the power unit and the manual for the gun (Miller).


milrat

[aametalmaster]

Good deal but its too far away for me. I have a Westinghouse about that vintage with the same Profax spoolgun as that one...Bob