Good day everybody... New to the board and MIG welding...
I recently purchased a Miller 140 auto set for my autobody work... I also purchased some mig wire from a welding supply store and upon arriving home realized they sold me .023 wire instead of .024...
My question is will the machine function properly with the .023 wire while its in .024 a/s mode ??? I personally don't think the .001 will make a noticeable difference, but I've been wrong before...
Thanks for the help..
r00n
Results 1 to 4 of 4
Thread: MIG wire size question...
-
11-15-2007, 01:51 AM #1
Junior Member
- Join Date
- Nov 2007
- Location
- canada eh
- Posts
- 3
MIG wire size question...
-
11-15-2007, 05:33 AM #2
Senior Member
- Join Date
- Sep 2005
- Location
- Salem ,Ohio
- Posts
- 3,647
It will be just fine...Bob
Bob Wright, Grandson of Tee Nee Boat Trailer Founder
Metal Master Fab Salem, Oh 44460
Birthplace of the Silver & Deming Drill
1999 MM185 w/185 Spoolgun,1986 Thunderbolt AC/DC
-
11-15-2007, 02:53 PM #3
Senior Member
- Join Date
- Nov 2007
- Location
- dallas tx
- Posts
- 325
unless you are out of tolerance by like ten thousandth's (i think)
it will will not make a difference.my daddy always said i was IRONHEADED....
feel free to P/M me
-
11-15-2007, 07:39 PM #4
Senior Member
- Join Date
- Sep 2002
- Location
- Clark County, NV
- Posts
- 2,696
Some have there stuff marked .025" for this size also, but all three sizes are the same to the welding machine and tips.
Reply With Quote
