Came across this late model sportbike frame. It has some damage.
Some racers install Delrin bump stops to limit steering rage in order to prevent tank-slappers. When they do this, they drill a hole and mount it in a weak area of the neck, its maybe .100 thick AL cast. During a tumble, this one got whacked pretty good..
Take a look at it and throw your 2 cents in. My idea is to strip, heat, bend the indented area out and then V/weld the cracks. An addtl reinforcement plate made from .120 wall 6061 in. Now from previous jobs, this cast al welds like crap, and I'm not sure it will come out winning any bueaty contests but should be sound..
It's bieng built as a display, but may see some trackdays down the road.
Have at it..
Results 1 to 2 of 2
Thread: Aluminum Frame repair project
02-22-2010, 08:11 PM #1
Aluminum Frame repair project
Last edited by Checkered Flag; 02-22-2010 at 08:13 PM.Two Dynasty 350's with Wireless pedals
Profax 250 weld positioner
Logan Turret lathe
RMD tubing bender
Enco vertical saw
Baileigh Auto cold saw
IR 80 Gal dual stage compressor
Misc Fab equipment
02-23-2010, 12:11 PM #2Senior Member
- Join Date
- Oct 2009
If I were doing it I wouldn't heat the damaged area since your likely to anneal it or over heat the area and ruin the aluminum. I would cut out a repair patch to go over the affected area and simply weld it into place making sure this is no running cracks from the damaged area possibly use LPI just to be sure.Miller syncrowave 200 runner with coolmate 4
and wp2025 weldcraft torch
Miller 125c plasma cutter