pictures of homemade welding carts

[goichi1]

The cart design looks really nice. I was wondering though, are you not concerned about the lack of air space behind the welders for air circulation? Page 19 of the 211 manual specifies 18" of space behind and in front for air flow. I believe the space requirement spec is the same for the Dynasty too, I know it is the same for my MM252.

It mentions the air space on page 17 of the Dynasty 200 manual.

I did think about that before I started building, but I am not too worried as I am a home garage hobbyist and will probably never run either machine full load or even close during my normal use, and if I do, I could always pull the machine forward to give it more area.

Thanks for the insight! Rich

[RegalX]

Cart for my 211 I finished up tonight....

Speed holes....



Leather strap for the tank...



Brass rivets to secure...

[coronan]

I'm planning a welding cart for indoor use. (Cart will Be for Tig and Stick)

When fabbing: WHAT DO YOU USE EVERY DAY?

Here's what i have come up with:
2 gas bottles
Tig Rod Can x 6 flavors
Stick Rod Can x 4 flavors
Water Cooler
Tig Accessory Box
Grinders 2
110 Outlet
Brushes
clamps
fire extinguisher
gloves 2 pr (tig, Stick)
Forklift Pockets
Framing Squares

Things to hang
Grinding Wheels
Grinders 2
stick lead
ground
pedal
pedal cord
Tig Lead
Hood
Face Shield
110 Cord
480 cord
Air Hose
Chipping hammer
3lb Sledge


Thoughts?
Too Much? Too Little?

Drawings will follow....

[coronan]

2013-04-22 14.13.45.jpg2013-04-22 14.14.07.jpg2013-04-22 14.14.25.jpg

[abyoder]

IMG_20130429_193451_480.jpgIMG_20130429_193504_405.jpgIMG_20130429_193527_801.jpgIMG_20130429_193600_736.jpgIMG_20130429_193611_517.jpg

[abyoder]

First project with my first mig welder (also used stick on this)......have a few more gizmos to add (power and air hose reels). The side work table was an afterthought but use it a TON!

[wagzilla]

here is some pic's of my welding cart.weldingcartandtable006.jpgweldingcartandtable011.jpgweldingcartandtable012.jpg