pictures of homemade welding carts

[Pass-N-Gas]

Here's the setup for my syncrowave 250



Rod boxes on both sides of the cart



Tig torch ready for action..



Front wheels / trailer tongue quick pin in to place to move it across town



the next cart will be for the Hypertherm 1250..it will be an off road version for the outback (behind the shop)

[Sberry]

Nice job, I am sure we would all like to see some other shop pics as well.

[Wheat]

If you build the cart....the welder will come...

[Showdog75]

My attempt at a aluminum cart for my dynasty. It's not finished but is anything in a welder's shop ? I'll update as progress continues.

[dogdog]

This is what I made for my 211.
I gleaned ideas from many posters.
I want to change the steering wheels to pneumatic casters, if I can't get some 1/2 in stainless rod for the handle, as it flexes too much and limits the steering.
I've had the drawers arounf for over 25 years, so included them.

Ligito:
Can you post a pic of how the steering was mounted

The bottom of your welding cart...

[ligito]

Here are some steps that I took, including a revision in design.
It was all new to me, so I struggled until it worked (kinda worked).
If I change the handle to 1/2 in it will be better but I may change to pneumatic swivel casters and keep the handle, it will steer better that way.

[ligito]

Here are a couple more shots.

[Hale Yeah Fabrication]

Here are a few pics of the Aluminium cart I made. My 200 DX sets on top but is in the shop right now.

[FusionKing]

Here are a few pics of the Aluminium cart I made. My 200 DX sets on top but is in the shop right now.

Now that is something different
When you get the Dynasty back on the cart, how about snapping another pic?

[Hale Yeah Fabrication]

Now that is something different
When you get the Dynasty back on the cart, how about snapping another pic?

You got it. Hopefully it will be soon....