Showdog proposed in Post #2
"Once I layed out the radius I welded some large angle on the inside of the radius to form the pipe to."
FDC proposed a Bending Jig in post #4
"take a piece of plywood cut it so that it follows the arc and projects about one inch out."
Black Wolf proposed the same idea in Post #13
"If it were me Gary, I would either bend it around a form similiar to what Showdog proposed, OR whip up a couple of dies (that you mentioned) and use your log splitter like a BIG pipe bender."
Miami talked about making a Jig and only presented that the jig could be cut using math- how else would one cut the jig or figger the Arc
Results 1 to 10 of 64
01-03-2010, 02:32 PM #23Ed Conley
Passport Plus w/Spool Gun
Miller 125c Plasma 120v
SO 2020 Bender
You can call me Bacchus