Lets see some projects, any

[spence648]

wow. that is awesome. never thought id say a camel is awesome but man nice work.

[pro70z28]

Thanks Rick & Spence. It was a fun project.

[spence648]

here is a log splitter we modified with a hydraulic lift. its missing the tongs and plumbing in the pics but you can get the idea. stupid me never took any final pics when it was all done.

[benningtonr]

It is sturdy and holds everything

[travlinbumm]

Wow

Thats a nice camel. Did you do all of it yourself?

I stink when it comes to artistic stuff. Carving / forming the foam would be far beyond me.

Good job

[monte55]

Thanks Rick & Spence. It was a fun project.

I just realized that you're the same guy as on the Vectric site. I have Aspire also . Great program. Your camel came out great.
Nick

[pro70z28]

Thanks travlinbumm & Nick. Yup, one in the same. Aspire sure is fun software.

[jimmy_pop]

dining table
http://www.flickr.com/photos/weldhou...7622780753279/

[MNT]

There had to be some curvature in the roof, did you flatten it out in a press?

Table looks awesome, and the work in progress pics show great attention to detail. Nice work.

[Daniel]

I will take a "Real" metal bed over a light weight aluminum bed any day..This is a two ton work truck.

If all I was doing was pulling a trailer it might be a different story the 3 bolt holes on the rear of the corners is for the bolt on tail roll, the 1/2" plate up front is for the 15K hydraulic winch.. The 3" square holes (now covered) is for the winch poles.. show me an aluminum bed I can do that to..

Sorry there bud, First pic of the sides look very bright to me. Though it was aluminium, my bad.