here is a brush guard that i made at work a few months ago
Results 1 to 10 of 10
Thread: brush guard
12-11-2009, 10:17 AM #1
Last edited by 6pakdakota; 12-11-2009 at 10:22 AM.
12-11-2009, 10:26 AM #2
Nice. Like the Made in The USA sticker...BobBob Wright, Grandson of Tee Nee Boat Trailer Founder
Metal Master Fab Salem, Oh 44460
Birthplace of the Silver & Deming Drill
1999 MM185 w/185 Spoolgun,1986 Thunderbolt AC/DC
Spool Gun conversion. How To Do It. Below.
12-11-2009, 12:07 PM #3
6pakdakota great job!
These brush guards aren’t for me, just not my taste, but I do appreciate what it takes to build one.
How did you bend the pipe that I have a red arrow pointing to? Did you use a mandrel bender, or fill with sand? What type of material did you use?
My hydraulic conduit bender will kink anything I’ve tried to date to bend that far past 90°.Caution!
These are "my" views based only on “my” experiences in “my” little bitty world.
12-11-2009, 12:38 PM #4
12-11-2009, 01:01 PM #5
Do you have L Arm #2 bender. Also nice pipe work
12-11-2009, 01:52 PM #6
12-11-2009, 09:05 PM #7Member
- Join Date
- Dec 2008
- Omaha, Nebraska USA
Nice looking brush guard. I bet Tiger Woods wish he had one on his SUV. How did you mount it? I bet that was the toughest part of the project.
12-11-2009, 09:16 PM #8Senior Member
- Join Date
- Apr 2009
- A State of Confusion
Very Nice Brush guard
12-12-2009, 05:27 PM #9
12-15-2009, 08:06 AM #10
I dont think I will hit a bear with it. but it sure looks good.