Hy, just feel to share whit you my first aluminium job made whit spoolmatic for my boat whit 50hp, but not enough power to lift a guy out of the water. A have fun built it aneway
Results 1 to 3 of 3
Thread: Wake board tour w/spoolmatic 30a
-
11-29-2009, 03:42 PM #1
Member
- Join Date
- Nov 2009
- Location
- Montreal, Quebec
- Posts
- 49
Wake board tour w/spoolmatic 30a
XMT 304 cc/cv 208/480 volts
Lincoln wire feeder LN-25 w/Contactor and Gas Solenoid, w/magnum 400 and 200 gun's (12 ft)
Spoolmatic 30a w/Flex Head tube 10'' XRA
Flexible Head Tig Torch w/Gas Valve (25 ft)
Foot Control RFCS-14HD
Side-to-side rotary-motion fingertip Current Control
Miller process Selector Control w/external solenoid valve
Stainless steel welding cart
Makita LC1230 Dry cut saw
www.ricau.ca
-
11-29-2009, 03:50 PM #2
Senior Member
- Join Date
- Jan 2007
- Location
- South Carolina, Dixie
- Posts
- 503
Spool matic wakeboard!
Wow. I would't have thought of that. I'm sure I would TIG this thing up if I was trying to build it. I work on boat towers, railings and all sorts of fabrications from aluminum pipe, etc. Nice. Too bad about the motor thing. Maybe a lrger one would work IF the boat could handle it.
Mustangs Forever!
Miller equipment.
-
11-29-2009, 04:17 PM #3
Senior Member
- Join Date
- Jan 2009
- Location
- Ohio
- Posts
- 191
Wake Board
Nice job makes the boat look great.To bad it doesn't work like you wanted Maybe this was a good start on next one. Still great job any ways.
VernonLast edited by Vernon; 11-29-2009 at 04:21 PM.
Reply With Quote
