I'm ready to rebuild the firewall. I cut the flanges out today for the intercooler tubes to pass through the firewall. I'll turn them down on the lathe & weld them in place & shape the sheet metal around them.
Results 1 to 10 of 10
Thread: Firewall Project
Hybrid View
-
10-23-2009, 10:06 PM #1
Senior Member
- Join Date
- Dec 2006
- Posts
- 612
Firewall Project
-
10-23-2009, 10:32 PM #2
Senior Member
- Join Date
- Sep 2005
- Location
- Salem ,Ohio
- Posts
- 3,655
Those are nice parts...Bob
Bob Wright, Grandson of Tee Nee Boat Trailer Founder
Metal Master Fab Salem, Oh 44460
Birthplace of the Silver & Deming Drill
1999 MM185 w/185 Spoolgun,1986 Thunderbolt AC/DC
-
10-24-2009, 04:07 AM #3
Senior Member
- Join Date
- Feb 2009
- Location
- banning ca.
- Posts
- 135
looking good keep the pics coming
gary...
-
10-25-2009, 07:09 PM #4
Senior Member
- Join Date
- Dec 2006
- Posts
- 612
Thanks glh. Got the flanges turned this weekend.
I put a groove around the edge of the flange for the firewall sheet metal. Once I install the o-ring and get in place I'll check the new gap with a feeler gauge and make a soft gasket to seal the flange to the firewall
-
10-25-2009, 07:11 PM #5
Senior Member
- Join Date
- Dec 2006
- Posts
- 612
Engine side of the flange bored to size for the tubes.
Got everything mocked up. The flanges on the windshield will be added to the inlet side. I'll turn those once I get the V-band clamp. Should be here any day. The outlet side attaches to the carb bonnet with hose & clamp.
-
10-27-2009, 08:18 PM #6
Senior Member
- Join Date
- Dec 2006
- Posts
- 612
Made a little more progress. I put the ol' foam mock up engine in it to make sure I get the angles right before I do any welding.
Reply With Quote
